This is default featured slide 1 title
This is default featured slide 2 title
This is default featured slide 3 title
This is default featured slide 4 title
This is default featured slide 5 title
 

Use Blood Glucose Monitors

1) Open the package with extreme caution.

2) Make sure that you have washed your hands with mild soap before proceeding further.

3) Take out the lancing device, glucose monitoring strips and the blood glucose monitor.

4) Insert a fresh (unused) lance in the lancing device. Now you need to set it to 3, which is usually achieved by rotating the base. Prime it.

5) Insert the code chip into the receptacle.

6) Once you’re done, turn on the device and wait till a code appears on the digital display. If no code appears, it means that the monitor and test strip is not synchronized properly.

7) Take out an unused glucose strip and be ready with it. Hold the lancing device vertically on the tip of your finger and release the trigger. A fine and tiny hole will be punctured in your skin. If you can’t see a small drop of blood, you might press around the area till you can.

8) Switch on the blood glucose monitor and pause until the blood icon flashes. After that, sweep the end of the glucose strip athwart the drop of blood.

9) Insert the glucose strip into the receptacle and wait for the results.

10) Note down the reading and remove the used lance as well as the glucose strip. Discard them. Turn off the device and keep it in a safe place.